Abstract
While metal additive manufacturing has seen significant growth in recent years, the surfaces produced often need post-processing to improve surface finish, mitigate residual stresses, and remove surface-connected porosity. Laser polishing, by means of remelting a thin layer of the surface, is one post-processing method being investigated for surface finish improvements and other surface enhancements. In this work, the surface morphology and microstructure of laser powder bed fused (L-PBF) stainless-steel 316 L (316 L) before and after laser polishing are characterized by optical microscopy (OM), scanning electron microscopy (SEM), electron back-scatter diffraction (EBSD), and transmission electron microscopy (TEM). In addition, the cross-sectional microhardness of the samples is measured and reported. Additionally, the as-built and laser-polished sample's tensile properties are characterized using uniaxial tension tests. The results indicate that the surface roughness of as-built 316 L (Sa = 4.84 μm) can be substantially reduced through laser polishing (Sa = 0.65 μm). After laser polishing, the average grain diameter is reduced and the proportion of low angle grain boundaries (2°~5°) is increased in the L-PBF 316 L. The maximum sub-surface hardness reaches 262 HV, and both the tensile strength and ductility of 316 L are increased after laser polishing. This enhancement is attributed to thermal cycling stresses, grain refinement, the elimination of surface defects, and dislocation strengthening after laser polishing.